Genie MAT-90

Home >

Genie

Genie MAT-90 ****NO LONGER AVAILABLE******

genie mat-90

Our Price: $29.99

Product Code: MAT 90

Description

Genie MAT-90

Features

GENIE GARAGE DOOR OPENER MINI REMOTE
MAT90 ( 12 Switch & 390 frequency)
************* WARNING *************
Moving Door can cause serious injury or death.
· DO NOT install transmitter unless the door operator’s safety reverse works as required by the door operator’s manual.
· Wall control must be mounted in sight of door, at least 5 feet above floor and clear of moving door parts.
· Keep people clear of opening while door is moving.
· DO NOT allow children to play with the transmitter or door operator.
If safety reverse does not work properly:
· Close door then disconnect operator using the manual release handle.
· DO NOT use transmitter or door operator.
· Refer to Door and Door Operators Owner’s Manuals before attempting any repairs.
_________________________________________________
Electrical Shock can cause serious injury or death.
· Power cord must be unplugged before attaching any wires,
· Be sure wire ends do not touch each other or other terminals.
If you have questions or if you need a manual, contact the distributor or manufacturer of the operator.
******************************************************************************************************************************
MAT – 90 DOOR OPENER REMOTE CONTROLLER
NOTICE: THIS REMOTE CONTROLLER MUST HAVE ITS INTERNAL CODE SWITCHES SET TO BE IDENTICAL TO THOSE IN YOUR OPENER BEFORE IT WILL WORK.
Your code block with dip switches can be found where you see the antenna wire hanging from the motor head (you may have to take the lens cover off). If antenna wire is not hanging from motor head then you have an external receiver which is a black box approx. 6" x 2" mounted somewhere in the garage with a antenna wire hanging from it (pop off cover to find code block with dip switches).
(This private code makes it possible for your remote controller to operate your door but not your neighbor’s. It also prevents his controller form operating your door.)
HOW TO SET YOUR PERSONAL ACCESS CODE
1. Put the edge of a coin in the slot to separate the front from the back of the controller and pry open the case to expose the twelve code switches.
2. Using the tip of a ballpoint pen as a tool set these code switches to the same positions as those in the original controller. NOTE: If your original controller had punch-out keys instead of switches, then set the switches in your new controller to the OFF or DOWN position to correspond with the keys which were punched out in the original controller. (Slide the switch actuator tab completely from one end of the slot to the other to change switch settings.)
3. If the original controller is not available, you may obtain the correct positions from the receiver code switches at the door opener power unit (motor head) Close the garage door and disconnect the electrical power from the door opener. If the door opener has a front lens, remove it to expose the switches.)
4. Copy the settings of these receiver switches as specified in Step 2 being careful to match the switch numbers.
5. Snap the controller case together, replace the door opener lens, and reconnect electrical power to the door opener.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Genie

	Genie GPT90-1 $18.68
	Liftmaster 64LM $22.60
	Liftmaster 66LM $29.99
	Edko Idler $95.84
	Liftmaster 62LM $29.55
	Liftmaster 373P $34.88
	Liftmaster 63LM $29.55
	Multi Code 4904 (No Longer Available) $29.99
	Elite EL25 Black/white camera kit $254.88